Plough Book Sales

Online Catalogue last updated 25th of June 2012


Milling Machine Operations by J.W. Barritt (1937)

Here you get valuable lessons that can make you an expert with a milling machine. You can get an introduction to the milling machine, the care of arbors, mounting the work, feeds and speeds, clearance angles and other essential topics.

You get step-by-step instructions and drawings that will teach you how to cut off a bras packing piece, cut off a cold rolled steel plate, saw a Bakelite plate, machine a brass spacer, a castiron bearing key, and several cast iron brackets.

Then you will be introduced to the indexing head and its use. You'll learn how to cut a tang on a tool-steel spot facing bar, mill a machine steel latch pin, mill a machine steel stud and a variety of shafts, machine a cast iron gear, a steel quadrant, a steel clutch with four flat teeth, a cast-iron bevel gear, a brass shoe, a cast-iron sole plate, a forged steel packing piece, a machine steel pull pin, a steel gear, a steel worm and more.

Most of the lessons show set ups for the horizontal milling machine. Towards the rear of the book are several lessons for the vertical milling machine. Regardless of the type of machine you have, the lessons are applicable. You'll learn how to approach the work so as to ensure accuracy and avoid costly mistakes.

Make you milling machine sit up and sing rather than make a chatter.

Code No. 004956, 110 pages, $17.00

This item is listed under the following subjects:

Workshop  
Home Page   |  Contents Page (Catalogue)   |  Information Pages   |  What's New   |  Links   |  Search Entire Site   |  Order Form

Plough Book Sales, P.O. Box 14, Belmont, Vic. 3216, Australia
Phone: 03 52661262 (International +61 3 52661262)
FAX: 03 52662180 (International +61 3 52662180)
E-mail: Stephen@ploughbooksales.com.au
© 2001-2008, Plough Book Sales